Chemical and Physical Properties of Bismuth Trioxide
Bismuth trioxide’s properties include monoclinic and yellow-colored powders as well as stable air stability. The melting point for bismuth is at approximately 825°C. It changes color to maroon upon heating and to yellow on cooling.Synthesis of BismuthTrioxide
1. Dropwise add aqueous solution sodium hydroxide with carbon dioxide to bismuth solution 8090. Mix thoroughly. After precipitation, the solution will remain alkaline and precipitate as a white volume-swelling bismuth dioxide hydrate Bi(OH).3. To make yellow bismuth trioxide, heat the solution and stir it briefly. You will get the final bismuth dioxide after washing it with water, filtering it, drying and then cleaning. 2. Dropwise, mix a 1.5mol/L sodium chloride aqueous solution (without carbon dioxide) with a 0.1mol/L bismuth nuitrate solution. Mix them in 1mol/L NaOH at 8090°C. After precipitation, the solution will remain alkaline. A white volume-expanded bismuth oxide hydrate Bi(OH),3 may precipitate. It is then dehydrated to yellow bismuth trioxide by heating a solution. Decant wash fifteen times using water without oxygen and carbon dioxide. Filter and dry. 3. Once the bismuth has been melted in the graphitecrucible, the oxygen flow creates an arc between the graphite and metal surfaces to heat up and oxidize. You should place the crucible in a large container. The oxygen must also be supplied continuously to keep it oxygen-rich. It takes about 750 to 800 degrees for the reaction temperature, after which -bismuth Trioxide of 99.8% purity or higher is produced. The product can then be cooled in water and/or on a cold plate to form a high temperature phase b. 4. Slowly stir the excess sodium carbonate solution with Bi(NO3)35H2O acidic solutions (20g) and mix in 2mol/L HNO3. To precipitate Bi2O2CO3, filter the solution, wash it, and then dry. It can be placed in an aluminum container and heated at 650K for approximately 1.5 hours. 5. Burn bismuth subnitrate at 400~500 to remove NO3- ions for about (3~4h): 2BiONO3=Bi2O3+NO+NO2+O2Once the fire is out, it cools down and all become lemony yellow.
6. You can wash 16 kgs of 99.9% wrought bismuth surfaces with a little bit of dilute acid. Next, you will need to use conductive waters to remove the nitric. After adding the 1:1 high-purity acid (35kg of nitric, with a relative density of 1.42 + 20L conductive), continue reacting for 10 minutes. The filtrate should be cooled slightly. After that, it must be evaporated and concentrated to a relative density of 1.9. Make a dilute solution of the bismuth nitrate. Stir it briefly, allow it to stand, strain it, and finally, dry it. Buffalotours advanced materials Tech Co., Ltd. (Buffalotours), a company that produces bismuth oxide powder, has over 12 years’ experience in chemical products development and research. We can provide high-quality bismuth oxide powder. Please contact us to send an inquiry.Inquiry us